A standard 240-volt electric tank water heater draws about 4,500 watts while heating, roughly 3,500-5,500 W depending on its elements. Heat pump water heaters draw only a few hundred watts in heat pump mode.
- Running watts
- 4,500 WTypical; 3,500–5,500 W across models
- Starting watts
- NoneNo motor surge
- Per day
- 13.5 kWh24 h of use, cycling
- Current
- 18.8 AAt 240 V while running
Figures checked against DOE, ENERGY STAR and manufacturer data on . Your model's label is the final word.
Watts by model and setting
Most electric water heater models draw between 3,500 and 5,500 W while running; a typical one draws about 4,500 W. Assumes a 4,500 W element heating about 3 hours a day for a family of four. ENERGY STAR estimates a heat pump model saves about 3,760 kWh a year for such a household.
- Element wattage: most 40-50 gallon residential tanks use 4,500 W elements; some use 3,500, 5,500 or 6,000 W
- Most tanks have two elements wired non-simultaneous, so only one heats at a time
- Hot water use, incoming water temperature and the thermostat setting drive how many hours it heats
- Heat pump (hybrid) water heaters move heat instead of making it and can be two to three times more efficient, falling back to elements in high-demand or cold conditions
Running an electric water heater on backup power
This is a 240 V appliance. It needs a generator with a 240 V outlet or a transfer switch or interlock installed by a licensed electrician; most portable power stations only supply 120 V.
- A 4,500 W, 240 V element is too much for small generators and most portable power stations; usually leave it off during outages
- If you do power it, it needs a 240 V generator through a transfer switch or interlock; never backfeed
- A full tank stays hot for many hours, so short generator runs can reheat it before showers
- Heat pump water heaters set to heat-pump-only mode draw far less and are much easier to back up
Add it to the generator calculator
Questions people ask
Can a portable generator run an electric water heater?
Only a 240 V generator of roughly 7,000 W or more, connected through a transfer switch, can run a 4,500 W element alongside a few other loads. Most people skip it during outages.
Do both elements in a water heater run at once?
In most residential tanks, no. The elements are wired non-simultaneous, so maximum draw is one element, typically 4,500 W.
How much less do heat pump water heaters use?
ENERGY STAR says they use less than half the energy of a standard electric tank, saving a family of four about 3,760 kWh a year.
Sources
- Virginia Cooperative Extension: Estimating appliance and home electronic energy use (DOE wattage table)
- A.O. Smith electric water heater specification (element kW, non-simultaneous operation)
- ENERGY STAR: Heat pump water heater savings
- U.S. DOE Energy Basics: Heat pump water heaters
- Eugene Water & Electric Board: Generator sizing considerations